Hi..can someone help me solve the problem.
I flashed 9XRPRO with opentx9xrpro 2.2.0 N367 firmware and can't get any telemetry data.The module is DJT, Rx is D4R-II.Also with the same setup I got telemetry on my Taranis X9D and I got telemetry on 9XRPRO with ersky9x firmware.So the wiring is not a problem.In telemetry screen I choose frsky D cable and inverted option.Did I miss something or it's not supported in opentx firmware yet?
9XRPRO with opentx firmware no telemetry data
- MikeB
- 9x Developer
- Posts: 17990
- Joined: Tue Dec 27, 2011 1:24 pm
- Country: -
- Location: Poole, Dorset, UK
Re: 9XRPRO with opentx firmware no telemetry data
Try without the inverted option.
Mike.
Mike.
erskyTx/er9x developer
The difficult we do immediately,
The impossible takes a little longer!
The difficult we do immediately,
The impossible takes a little longer!
Re: 9XRPRO with opentx firmware no telemetry data
Any other suggestions anybody?
- bob195558
- Posts: 2377
- Joined: Sun Dec 16, 2012 7:24 pm
- Country: United States
- Location: New England, Vermont
- Contact:
Re: 9XRPRO with opentx firmware no telemetry data
Suggestions:
1) Maybe go back to erSky9x to see if D-Series (PPM protocol) DJT telemetry still works when using erSky9x firmware.
2) Purchase the XJT module to be able to try PXX protocol.
Bob B.
1) Maybe go back to erSky9x to see if D-Series (PPM protocol) DJT telemetry still works when using erSky9x firmware.
2) Purchase the XJT module to be able to try PXX protocol.
Bob B.
Er9x on 9x radio, with Smartieparts Programmer and TelemetrEZ Board.
ErSky9x on Taranis, Sky9x, 9Xtreme radios.
3D-Printing: (https://openrcforums.com/forum/viewforum.php?f=129).
ErSky9x on Taranis, Sky9x, 9Xtreme radios.
3D-Printing: (https://openrcforums.com/forum/viewforum.php?f=129).
Re: 9XRPRO with opentx firmware no telemetry data
I wrote before that telemetry worked with ersky9x firmware on my 9xrpro using DJT module and D4R-II rx.. just want to get a clue why it's not working on opentx (9xrpro) firmware and 9xrpro.This is just my older setup. My new setups all works on Taranis internal or external XJT module and x4r-sb or xsr using sbus..tnx for comment,Bob
Re: 9XRPRO with opentx firmware no telemetry data
9xr pro and djt with with telemetry cable is not working on opentx 2.2.0. I've gone into the source code and the serial port 2 code in the sky9x target is non functional. I suspect it was broken when taranis specific changes were made. I've fixed some at least gotten rssi to work but I need to polish the code a before I make a pull request. I could be a while.