Gspd and Galt

[stilllearning]

Equipment:
DJI NAZA-M V2
FrSky D8R-II Plus
FrSky FBVS-01 Battery Voltage Sensor
Turnigy 9XR Pro
Frsky Telemetry & Head Track Module Extent Cable

I'm trying to understand how to set up a model to display the Gspd and Galt. I have the telemetry screens with the items showing but I obviously don't have them set up correctly to display the data. Could someone help me with some info to do this? Thanks!!

[MikeB]

What Tx module are you using?

Mike.

[stilllearning]

DJT

[Kilrah]

Sounds like you neither have a GPS sensor connected nor a Naza to FrSky bridge? How do you expect the data to reach the radio?

[stilllearning]

That's what I'm trying to determine. I posted my hardware hoping that someone would tell me specifically what I needed to make it work or if I needed to set up the radio differently. I'm new to this and just been lucky getting things to work so far. What other hardware do I need? Thanks!!

[Kilrah]

With your setup I'm not sure, you'll have to do some research. FrSky's GPS will only work with X series receivers, not with D series.

There are bridges that can take the info from the Naza and relay it to the receiver, but I don't have links or names at hand and they may also only work with smart port-equipped X series.

[stilllearning]

I hoped with the Naza GPS and telemetry cable I could get the data. Apparently not. I added a flight pack voltage sensor and I'm out of connection ports. I appreciate the help and suggestions.