Page 1 of 1

Arduino + RFM69HW DIY TX Modul

Posted: Fri Jan 29, 2016 6:07 pm
by AlexF
Hi,

is it possible to use an RFM69HW module on an Arduino board as a TX module for openLRSng?

Pinouts of the RFM69HW

1 RESET I/O Reset trigger input
2 DIO0 I/O Digital I/O, software configured
3 DIO1 I/O Digital I/O, software configured
4 DIO2 I/O Digital I/O, software configured
5 DIO3 I/O Digital I/O, software configured
6 DIO4 I/O Digital I/O, software configured
7 DIO5 I/O Digital I/O, software configured
8 3.3V - Supply voltage
9 GND - Ground
10 ANA RF signal output/input.
11 GND - Ground
12 SCK I SPI Clock input
13 MISO O SPI Data output
14 MOSI I SPI Data input
15 NSS I SPI Chip select input
16 NC - Connect to GND

Thanks,

AlexF.