No access to OpenLRS configurators

Support and help for the OpenLRS firmware.

Moderator: kha

Post Reply
gwoodgeno
Posts: 2
Joined: Tue Jun 17, 2014 10:55 pm
Country: -

No access to OpenLRS configurators

Post by gwoodgeno »

Greetings All,
I can upload OpenLRSng firmware into my Orange Tx and my Orange Rx utilizing the Arduino environment. No Problem.
I can upload firmware into my Tx with the Chrome configurator. The problem comes when I try to connect.

When trying to edit my perams via Chrome configurator I get:
17:51:37 -- Serial port successfully opened with ID: 1
17:51:48 -- Start message not received within 10 seconds, disconnecting
17:51:48 -- Serial port successfully closed

If I attempt it using the DTF UHF Companion I get: Read Error!

I have tried many reloads, holding buttons down in and not in every step. I performed a complete test on my FTDI board.
I really want to progress here but I am totally stuck on this.
Please Help :shock:

evilstoat
Posts: 1
Joined: Sun Jun 22, 2014 4:42 am
Country: -

Re: No access to OpenLRS configurators

Post by evilstoat »

I'm experiencing the same problem, I just use arduino to configure, only got the configurator to work with just rx for some reason?
pa2rdk
Posts: 2
Joined: Sat Apr 26, 2014 4:19 pm
Country: -

Re: No access to OpenLRS configurators

Post by pa2rdk »

I succeeded more or less stable by turning on power on the TX while the configurator was waiting for the response. gives you 10 sec's.

Post Reply

Return to “OpenLRS”