Hello,
This is my first post to openrcforums though I have browsed it quite a bit through my learning of programming with ER9x. I have a question on the programmer from 9xrprogrammer from rperkins. I was very happy to get it very quickly and I am a couple of minutes from pulling out the soldering iron and starting my long awaited flash of my 9x but I am unsure which side of the ribbon is wire number 1 and which is wire 6 when looking at the USB and ribbon from the top. Is the left side the # 1 cable when viewed from above? Any help would be greatly appreciated as for I don't want to mess this up. Thank you in advance.
Also, would this be correct for the 6 pin?
Pin 1=MOSI
Pin 2=+5v VCC
Pin 3=Reset
Pin 4=SCK
Pin 5=MISO
Pin 6=Ground
USBASP 6 pin question
Re: USBASP 6 pin question
Hi
Here is a pic that shows the pinouts as if you were looking into the socket on the small board
http://9xrprogrammer.com/index.php/lear ... p-hardware
I took that pic and reversed it so it shows the cable end also
Hope this helps and good luck. let me know if you need any more assistance
thanks
Here is a pic that shows the pinouts as if you were looking into the socket on the small board
http://9xrprogrammer.com/index.php/lear ... p-hardware
I took that pic and reversed it so it shows the cable end also
Hope this helps and good luck. let me know if you need any more assistance
thanks