Page 1 of 1

9xr Pro blade 350qx transmitter format, anyone have the set up?

Posted: Tue Mar 28, 2017 11:22 pm
by WoodsyOwl
I need help programming my Turnigy 9xr Pro for my blade 350qx does anyone have the transmitter set up? I have searched far and wide in YouTube land and even HobbyKings site but can't seem to find a template to just copy, I am a noob with open TX transmitters so I really want to find something I can use with the existing ersky9x firmware without having to download anything but I am starting to wonder if that's even possible? Any help would be greatly appreciated!


Sent from my iPhone using Tapatalk

Re: 9xr Pro blade 350qx transmitter format, anyone have the set up?

Posted: Wed Mar 29, 2017 3:53 pm
by MikeB
Have a look at this thread: https://www.rcgroups.com/forums/showthr ... ade-350-Qx.

While the settings are shown as for er9x, ersky9x should use the same settings.

Mike.

Re: 9xr Pro blade 350qx transmitter format, anyone have the set up?

Posted: Wed Mar 29, 2017 4:17 pm
by WoodsyOwl
MikeB wrote:Have a look at this thread: https://www.rcgroups.com/forums/showthr ... ade-350-Qx.

While the settings are shown as for er9x, ersky9x should use the same settings.

Mike.
Thank you Mike, I will check this out!


Sent from my iPhone using Tapatalk

Re: 9xr Pro blade 350qx transmitter format, anyone have the set up?

Posted: Thu Mar 30, 2017 10:32 pm
by WoodsyOwl
Well I guess I need it spelled out a bit more, while this was helpful I am a novice with these remotes so the search continues I am learning a ton as I go along which is good though


Sent from my iPhone using Tapatalk

Re: 9xr Pro blade 350qx transmitter format, anyone have the set up?

Posted: Wed Apr 05, 2017 12:12 pm
by WoodsyOwl
I finally figured it out!, what a happy night, turns out I was over complicating "everything" if anyone see's this and is having similar issues being a newb you need to just focus on the basic (mixes) everything else is taken care of by the on board flight electronics, yes you can tweak things as you learn more about the controller but do not let it make your brain explode to get it in the air and flying just focus on channels 1-4 and assigning your trainer switch to channel 6, you can worry about expo, curves etc.... later as you learn

Re: 9xr Pro blade 350qx transmitter format, anyone have the set up?

Posted: Wed Apr 05, 2017 12:40 pm
by Daedalus66
Congratulations! The secret is in identifying the fundamentals.

Re: 9xr Pro blade 350qx transmitter format, anyone have the set up?

Posted: Wed Apr 05, 2017 12:45 pm
by WoodsyOwl
Thank you!