Identifying which pots for my new 6 pos switch
Posted: Sun Oct 19, 2014 7:53 pm
Hi guys, this is only a little embarrassing because I have had no problem in setting up the mixes that I have needed so far but I could really use some further tutelage and exercises to get to know ER a little better.
I have received and installed a 6 position switch from a well known vendor on Ebay that offers the item and 4 variable resistors that you install in place of POT # 2. Now of course I am trying to convert the original mix I had using the AIL and IDO,1,2 Switch to arrive at 6 flight modes for my APM 2.6 F.C.
I am trying to make a mix with the FRSKY, NoTemplates version of ER9X that I have burned on the MCU of my 9X. Would some kind soul tell me how to incorporate this for CH5 Switch to command the 6 Flight Mode - Arducopter 3.XX in Mission Planner.
On a side note they have recently added to their product line-up, 6 LED indicator to assure you of the switch position. I have it on the way naturally, it is an obvious next step but thoroughly useless if I cannot manage to figure out what the mix will be.
I have received and installed a 6 position switch from a well known vendor on Ebay that offers the item and 4 variable resistors that you install in place of POT # 2. Now of course I am trying to convert the original mix I had using the AIL and IDO,1,2 Switch to arrive at 6 flight modes for my APM 2.6 F.C.
I am trying to make a mix with the FRSKY, NoTemplates version of ER9X that I have burned on the MCU of my 9X. Would some kind soul tell me how to incorporate this for CH5 Switch to command the 6 Flight Mode - Arducopter 3.XX in Mission Planner.
On a side note they have recently added to their product line-up, 6 LED indicator to assure you of the switch position. I have it on the way naturally, it is an obvious next step but thoroughly useless if I cannot manage to figure out what the mix will be.