motors arm in Cleanflight GCS not with transmitter
Posted: Sat Aug 06, 2016 5:25 pm
My Transmitter is a 9 XRPro
My receiver FrSky D4R-II
My receiver seems to bind ; red light flashes and green light on
Receiver is connected to battery.
When I move sticks on my transmitter nothing happens.
receiver is set; AETR1234, RSI Channel 8
(Channel 3 and Channel 4 connected by jumper/Channel2 outputs RSSI)
simple Mixes are set on the transmitter.
Computer is connected to NAZE 32 flight controller
When I open the receiver page in my GCS (Cleanflight) I see nothing happen(except two running lines).
Why is my transmitter not functionning??
My receiver FrSky D4R-II
My receiver seems to bind ; red light flashes and green light on
Receiver is connected to battery.
When I move sticks on my transmitter nothing happens.
receiver is set; AETR1234, RSI Channel 8
(Channel 3 and Channel 4 connected by jumper/Channel2 outputs RSSI)
simple Mixes are set on the transmitter.
Computer is connected to NAZE 32 flight controller
When I open the receiver page in my GCS (Cleanflight) I see nothing happen(except two running lines).
Why is my transmitter not functionning??