Hi everyone,
Any one out there set-up the following successfully on a V-tail craft? :
Ailerons using 2 servos in 2 channels, switch to hi & low rates, AND using same channels for using ailerons as switched air brakes AND play a meaningful track when rates and air brakes are switched ?
Following on from the above, the next step I would like to achieve is to enhance the above airbrake set-up by adding some down elevator (its a V-tail, remember). This I believe would be crow.
I have been playing for hours with this - although good practice it is becoming a headache !!
Thanks for your help.
Dynamic-S setup with Taranis Plus
Re: Dynamic-S setup with Taranis Plus
Lots of readers but no replies !!
For those who are interested, I have finally triumphed and have now set up my Dynamic-S and ST Blaze as I had hoped for. V-tail operates correctly and the rates for Ele and Rud are governed by dedicated switches. Ail rates are also governed by a dedicated switch, crow braking is achieved via a dedicated switch and slider. Every switch action on the radio plays a relevant audio track depending on the switch's position. What more could you ask for ?
For those who are interested, I have finally triumphed and have now set up my Dynamic-S and ST Blaze as I had hoped for. V-tail operates correctly and the rates for Ele and Rud are governed by dedicated switches. Ail rates are also governed by a dedicated switch, crow braking is achieved via a dedicated switch and slider. Every switch action on the radio plays a relevant audio track depending on the switch's position. What more could you ask for ?