Dynamic-S setup with Taranis Plus

Post Reply
JohnWay
Posts: 22
Joined: Wed Jan 20, 2016 3:56 pm
Country: -

Dynamic-S setup with Taranis Plus

Post by JohnWay » Thu Jan 21, 2016 3:52 pm

Hi everyone,
Any one out there set-up the following successfully on a V-tail craft? :
Ailerons using 2 servos in 2 channels, switch to hi & low rates, AND using same channels for using ailerons as switched air brakes AND play a meaningful track when rates and air brakes are switched ?
Following on from the above, the next step I would like to achieve is to enhance the above airbrake set-up by adding some down elevator (its a V-tail, remember). This I believe would be crow.

I have been playing for hours with this - although good practice it is becoming a headache !!

Thanks for your help. :)

JohnWay
Posts: 22
Joined: Wed Jan 20, 2016 3:56 pm
Country: -

Re: Dynamic-S setup with Taranis Plus

Post by JohnWay » Sat Jan 23, 2016 6:15 pm

Lots of readers but no replies !!

For those who are interested, I have finally triumphed and have now set up my Dynamic-S and ST Blaze as I had hoped for. V-tail operates correctly and the rates for Ele and Rud are governed by dedicated switches. Ail rates are also governed by a dedicated switch, crow braking is achieved via a dedicated switch and slider. Every switch action on the radio plays a relevant audio track depending on the switch's position. What more could you ask for ? :D

Post Reply

Return to “openTx model setup”