Sending different pulses with a switch

Post Reply
Leonard
Posts: 25
Joined: Fri Jan 23, 2015 6:45 pm
Country: -

Sending different pulses with a switch

Post by Leonard » Fri Mar 13, 2015 9:28 am

I have a Beier USM-RC-16 soundand light module which have a EKMFA mode where it takes pulses to control a feature.
Example:
I have to flip the switch 3 times forward and one function is triggered.
I then flip the switch 5 times forward and another function will react.

I will like it to be put on the different switches on the radio, so example the SA will send 2 pulses, the SB will send 3 pulses and so on.
The length of the pulses must be 100mS.
--
Leonard, Denmark
http://rc.leonard.dk/

Using FrSKY Taranis X9E with OpenTX 2.1.8 non-EU

Leonard
Posts: 25
Joined: Fri Jan 23, 2015 6:45 pm
Country: -

Re: Sending different pulses with a switch

Post by Leonard » Fri Mar 13, 2015 10:03 am

Don't hurry, I think I have a solution-
I will post it here later today or tomorrow.
--
Leonard, Denmark
http://rc.leonard.dk/

Using FrSKY Taranis X9E with OpenTX 2.1.8 non-EU

Leonard
Posts: 25
Joined: Fri Jan 23, 2015 6:45 pm
Country: -

Re: Sending different pulses with a switch

Post by Leonard » Sat Mar 14, 2015 3:02 pm

Playing and testing with logical switches and the Timer function it now works.
And I also learned a lot other things about making the different switches to do special things.

It is getting better and better :-)
--
Leonard, Denmark
http://rc.leonard.dk/

Using FrSKY Taranis X9E with OpenTX 2.1.8 non-EU

keninvic
Posts: 5
Joined: Tue Jul 03, 2018 4:41 am
Country: -

Re: Sending different pulses with a switch

Post by keninvic » Tue Jul 03, 2018 4:46 am

Yes, this is an old post, but I have same problem, how did you do it using the logical switch timer function?

Post Reply

Return to “openTx model setup”