Hello guys, it‘s me again!
I‘m trying to set the throttle trim as flap control.
In FP1 (thermal mode) I want the throttle trim all the way down and the flaps neutral. When I move the trim upwards, the flaps should move down in steps to full deflect.
The opposite applies to FP2 (speed). Trim all down, flaps neutral and with trim up, the flaps go up.
Can you help me please?
Thanks
Throttle trim as flap adjuster
- MikeB
- 9x Developer
- Posts: 17993
- Joined: Tue Dec 27, 2011 1:24 pm
- Country: -
- Location: Poole, Dorset, UK
Re: Throttle trim as flap adjuster
I think what you need to do is:
1. On the "Inputs" don't include the throttle trim with the throttle stick, this frees off the throttle trim.
2. On the "Inputs", create a new input with source Ttm.
3. Make sure FP1 and FP2 use their OWN throttle trim.
4. Create suitable mixes to control the flaps using the Input created in step 2, most likely using a weights and offsets of 50% or -50%.
Mike
1. On the "Inputs" don't include the throttle trim with the throttle stick, this frees off the throttle trim.
2. On the "Inputs", create a new input with source Ttm.
3. Make sure FP1 and FP2 use their OWN throttle trim.
4. Create suitable mixes to control the flaps using the Input created in step 2, most likely using a weights and offsets of 50% or -50%.
Mike
erskyTx/er9x developer
The difficult we do immediately,
The impossible takes a little longer!
The difficult we do immediately,
The impossible takes a little longer!