Throttle trim as flap adjuster

Post Reply
Koarl
Posts: 203
Joined: Sun Jul 01, 2012 5:08 pm
Country: -

Throttle trim as flap adjuster

Post by Koarl » Mon Feb 19, 2018 5:26 pm

Hello guys, it‘s me again!

I‘m trying to set the throttle trim as flap control.
In FP1 (thermal mode) I want the throttle trim all the way down and the flaps neutral. When I move the trim upwards, the flaps should move down in steps to full deflect.
The opposite applies to FP2 (speed). Trim all down, flaps neutral and with trim up, the flaps go up.

Can you help me please?

Thanks

User avatar
MikeB
9x Developer
Posts: 15522
Joined: Tue Dec 27, 2011 1:24 pm
Country: -
Location: Poole, Dorset, UK

Re: Throttle trim as flap adjuster

Post by MikeB » Mon Feb 19, 2018 11:05 pm

I think what you need to do is:
1. On the "Inputs" don't include the throttle trim with the throttle stick, this frees off the throttle trim.
2. On the "Inputs", create a new input with source Ttm.
3. Make sure FP1 and FP2 use their OWN throttle trim.
4. Create suitable mixes to control the flaps using the Input created in step 2, most likely using a weights and offsets of 50% or -50%.

Mike
ersky9x/er9x developer
The difficult we do immediately,
The impossible takes a little longer!

Koarl
Posts: 203
Joined: Sun Jul 01, 2012 5:08 pm
Country: -

Re: Throttle trim as flap adjuster

Post by Koarl » Tue Feb 20, 2018 7:42 pm

Thanks!

Post Reply

Return to “openTx model setup”