openrcforums

I just found this while I was searching for channel order info on the multi RF module... "Create a new model and confirm that the channel order is set to AETR (This is really important - this is for all protocols - even for DSM as the MULTI-module firware will change the transmitted channel ord...

This is the module im using
http://www.banggood.com/2_4G-CC2500-A71 ... 48377.html

Also, a bit more clarification...I have owned a 9XR for a couple years, had ERSKY9x on it for at least the last year...it worked fine with my Orange OpenLRS module and Rx. I sold the 9XR and bought a 9XR Pro and those two receivers and a Multi RF module all about the same time, the day I got the 9XR...

Daedalus66 wrote:Here are some screen shots that should help.

Those three screenshots look exactly like my screens. Just for clarification, those screens looked like that and had those correct settings before I even started this thread.

Then you must have changed something else that should be left alone. Can you do as Joao asks? I have downloaded the eepsky app, installed and connected, I have tried the simulator and the throttle is moving as it should. I then went to my receiver and plugged in a servo on "CH1 THRO" and ...

Daedalus66 wrote:That's it. Is it working correctly for you? Everything you need is on that page.

If you still have a problem, create a new model And it should be correct.

Those settings were like that before I created the model I was using...so at your suggestion I created another new model...no change.

Daedalus66 wrote: The diagram at the bottom right shows how the sticks are configured and should read Rud Thr Ele Ail for Mode 2. It does not show channel order.

I am showing MODE 2 and "Rud Thr Ele Ail" next to it.

Kilrah wrote:You've likely got the radio configured for mode 1.

I went into radio setup, then controls, in there I have channel order set to TAER and below that a few lines it says MODE 2. Unless there is some other place to set the mode then I have it set to MODE 2 correctly.

I have a 9XR Pro with ERSKY9x for the 9XR Pro firmware installed (r220). This is a new radio. I calibrated the sticks then set the channel order to TAER since I mostly use Spektrum receivers i wanted the radios channel order to match the Rx order...I thought this would simplify things. I made a new ...

It's my understanding that with the 9XR Pro you can save a file of your model setup and share it...like a heli model with all the throttle/pitch curves, mixing and switches programmed in. Is there a place on this forum where those types of files are being shared? It would save me a lot of time to ju...

SOLUTION: The file I was using was for the 9x, I re-flashed the firmware using the "ersky9x for 9XR-PRO" file and its all working fine now.

Anyone know where I can find a sexy British female voice pack for the 9XR Pro?

Now if I could find a voice pack with a sexy British accent I'd be in heaven!

I just flashed "ER9X for Mega128 processor"...I will do some testing and get back to you...thanks for your quick response.

Hmm...looks like I used "ER9X standard"

I get an error after making chages to my models and then flashing the EEPROM back onto the transmitter. It always says there was an error and that it is Formatting EEPROM. I have a Turnigy 9XR (bought in 2014) with the m128 chip. I flashed the ER9X r820 firmware onto it Im using EEPE 419 I can get t...