openrcforums

When is 2.4 due?
Thanks!

Hi Group!
Seems I have tried everything; two devices (servo and led lights, both known good).
The output screen shows deflection from zero in only one direction.
My old 9XR transmitter goes from full negative to full positive with a switch on the channel.
Any ideas?
Thanks!

Does anyone know if there is a setup for "full house" aileron mix for the X7?
With camber changing and a pot for the flaps?
(like the E-Soar Plus for the X9)
Thanks!

Found out the flight stabilizer was looking for the opposite polarity. I set in -100, and it works!

Thanks Da!
What I have doesn't work. I'll upgrade firmware and see if the sGEA works.
Mike

Hi Forum,

Can someone help with code for assigning the gear switch to control a stabilizer on channel 5?

Here is my code:

CH5 100FULL GEA

Thanks!
Mike

Yup! I deleted my most recent model, and all is fine.
Thanks!

Hi Group!
I keep getting an EEPROM Overflow error. I have 6 models stored. Any ideas?
Thanks!
Mike

Hi Group,

When trying to do "read memory from Tx", I get: avrdude.exe: error: could not find USB device "USBasp" with vid=0x16c0 pid=0x5dc

Do I need to update drivers for Win 10?

Where can I find these?

Thanks!
Mike

Thanks brother!
Have a nice day,
Mike

Hi group, Can anyone think of a reason for this? Here is my code: CH4 100 AIL d + 100 CH14 CH14 10P3 ID1 + 100 P3 ID2 + 100 THIS S CH6 100 AIL d + 100 CH16 CH16 -10P3 ID1 + -100P3 ID2 + 100 THIS S I have both Slow Down and Slow Up set at 3 for the THIS entries. Thanks! Mike :)

Awesome! I think I understand that. Will give it a try!
Best,
Mike

Hi Group!
I am having trouble programming a rudder to aileron mix. I would like to have an off switch, with, maybe 30% mixing of rudder to the aileron channel. Could someone list the steps?
Thanks!
Mike

Thanks man!
Why would anyone want that feature?

Hi Group,

My trim tabs for elevator and throttle are swapped. Strange! When I push the elevator trim tab up, my motor starts!

Thanks!
Mike

That is correct.
Thanks Mike!

Hi Group!
Thanks for the replys.
I have successfully flashed the firmware with this USB programmer: USBasp USBISP AVR 10 Pin USB Programmer 3.3V/5V 51 ATMEGA8 w/ Cable & adapter
The firmware and radio are working fine
It is wired as per above 6 Pin diagram.
Thanks guys!

Dear Group, I have installed the ER9X firmware, and want to transfer a complete set of parameters from one radio to another. I found the "Read Memory from Tx" button, but when I hit it I get errors: avrdude.exe: warning: cannot set sck period. please check for usbasp firmware update. avrdu...