openrcforums

Tried both, no binding.
Thanks for the suggestions guys
Do appriciate it!

Think Im going to look at the rx firmware next, frustration[emoji14]

Hi Guys, If anyone can point me into the right direction please do so, my rain stopped functioning and I'm drawing blanks. My previous setup was a FlySky 9X with 9Xtreme board and DJT module. It was connected to a D4R-II and working just fine. I've build a new quadcopter and figured I'd upgrade to a...

Hi Mike, just wanted to give you a big thanks for your knowledge and help. Updated the firmware and everything is working now. Just shows that the problem was 100% me, not the firmware nor the hardware. ;) a well. Lesson: dont use the -f when flashing and dont update if everything is working just fi...

Ive checked the setting and turned it off. Still got the switch error however after a few seconds it is gone. After this all switches work as intended. Only downside is i want to use one of these switches as "arm" switch. However due to this error and delay in function i get a problem, as ...

To early to celebrate.
I figured seeing the numbers at the top left for the custom firmware would mean it is solved. However, still got switch error and switches do not work...

New TelemetrEZ board and problem solved. Thanks for the support!

Hi Mike, Reading the post you just mentioned I feel I figured out what might have gone wrong. Do I understand it correctly: If I connect my smartieboard via USB and flash firmware on it, if I do not power the Tx it will flash the TEZ board, if I do power it it will flash the Tx board? When this is a...

Used your customer FW.

Without DJT module it's stuck at 0000
With DJT modue it's also stuck at 0000

Checked a few things today, i bought the smartieboard in december. Taking the deliverytime into account there are two firmware versions i could have used, r808 from 12 nov 2013 and perhaps r809 from 22 jan 2014. I tried both, er9x-frsky.hex , but both give me the switch error. Turning off the Teleme...

Im net receiving any rx or tx rssi feedback for as far as I can tell, doesnt show this info on the screen as it did before. Ill see if I can figure out what version I had before, downside is I didnt note this down so I'll have to go back and try to figure it out by data. Will get back when I tried a...

Hi Guys, I can almost hear you think "one of these again" The thing is, I've been browsing the web for 3 days now, tried alot of stuff and just can't get it to work. So I've decided to update my er9x firmware from a version working perfectly fine (big regret, but no turning back) My hardwa...