Search found 6 matches
- Mon Jan 06, 2020 4:18 pm
- Forum: Software
- Topic: Telemetry and OpenTx 2.3.4 Companion.
- Replies: 7
- Views: 6381
Re: Telemetry and OpenTx 2.3.4 Companion.
Well, I had just updated to companion 2.3.4 and my telem sensors do not work when uploaded from companion. They are fine when discovered on the 9XD+ and calculated values work. But when you read the models into companion, do an adjustment and upload to tx, none of the telem works. I did a test and c...
- Thu Jul 30, 2015 6:02 pm
- Forum: openTx
- Topic: OpenTX 2.1 released!
- Replies: 156
- Views: 258709
Re: OpenTX 2.1 released!
I tried the latest release earlier this week. Most of the changes seem understandable. But when it comes to the telemetry, I am just lost. I can get my devices detected, but am finding it so difficult to work out power, mah etc. I think this release has taken open tx out of the comfort zone for many...
- Sat Dec 21, 2013 7:58 pm
- Forum: FrSky Taranis radio
- Topic: Telemetry using variometer and FAS-100
- Replies: 14
- Views: 9210
Re: Telemetry using variometer and FAS-100
Sorted, look at this link http://openrcforums.com/forum/viewtopic.php?f=97&t=4081 You need to set the X8R receiver into D16 mode in the set up.
- Sat Dec 21, 2013 7:19 pm
- Forum: FrSky Taranis radio
- Topic: New variometer
- Replies: 26
- Views: 16898
Re: New variometer
I can't thank you enough for this info. I have been trying for 3 days to get Alt working on my tranis. Why is there no info about this in the instructions sheet about setting channels to D16. All working now. THX again
- Sat Dec 21, 2013 7:03 pm
- Forum: FrSky Taranis radio
- Topic: Telemetry using variometer and FAS-100
- Replies: 14
- Views: 9210
Re: Telemetry using variometer and FAS-100
Yes, Set to vario in the telemetry. Have now flashed Tranis to latest firmware, still no success.
- Sat Dec 21, 2013 5:26 pm
- Forum: FrSky Taranis radio
- Topic: Telemetry using variometer and FAS-100
- Replies: 14
- Views: 9210
Telemetry using variometer and FAS-100
I have been advised to post my question here about my Tranis. I have a problem with the new vario not talking to the tranis, I have used the vario as a bridge for the FAS-100, so use the setup explained in post on another site. After connecting up as per the pics, I found the Volts, Amps and Mah all...