openrcforums

|Solved| -Taranis on in Bootloader mode > connect USB to PC -Device manager -Universal Serial Bus Device>FrSky Taranis Bootloader -Right click>Update Driver Software -Browse my Computer -Let me pick from a list of drivers on my computer -Select USB Mass Storage Device and click next This instantly ...

I do not see the two drives appear after connecting. -In device manager, with the Tx On in Bootloader mode, I only see the FrSky Taranis Bootloader. If I plug the USB in the TX when the radio is off, then I only see the STM32 BootLoader. -In Devices and Printers, I see Unspecified STM32 Bootloader w...

Is the C9X 2.X and Taranis Bootloader v1.0 compatible with Win 8.1? My tablet device manager sees the FrSky Tarnis Bootloader but companion prompts "No Radio found". I've been down this road before with my Windows 7 desktop using Pre C9x 2.x and using Zadig to update the USB driver to get ...

I think you misunderstood the question. I am referring to both Companion programs C2.01 and C1.52 that are installed and running on my PC. The problem is after I connect my USB cable to my Tx to download (copy) my models to my PC, the actual "Read Models and setting from Radio" button proc...

Thanks, I disabled the splash screen and that worked.

My C9x 1.52 still downloads the models much quicker then 2.01 on the same PC. This must be a bug in C9x 2.0. Worth looking into for sure.

-Noticeable Companion 2.0.1 connection delay. When "Reading Model" from Taranis, the download process is much slower now (about 15 seconds slower). -Taranis Tx loads about 3 seconds slower. Not a huge problem now, but I sure would like my radio to load/turn on faster in the event of an acc...

UPDATE: I got it working now.

I had to update my Tx as well with the new v2.0.1

I will test tomorrow on my models.

I just install C9X 2.01 on my Win 7 PC and I get Radio Not Found. Great here I go again with the driver issue. Oddly enough, I still have C9X 1.52 on my PC and it still works just fine (No radio connection problems)

Holding center trim tabs in while turning on doesn't do anything.

Taranis V r2940

I spent hours trying figure out why my USB worked at one time then quit working with my Taranis. I ended up unplugging three USB devices on my PC to finally get my Taranis to communicate to my USB. Hard to believe something as simple and two many active USB ports in use caused this much trouble. I h...

Kewl! thanks you for clearing that up. I will give it a shot today.

How do I achieve linking two X8R's together for 16 Channels? I know the SBUS plays a part in this but do I plug a standard servo wire with male connectors on both end into the SBUS ports of the Rx's? The manual states to disable Telemetry on one Rx so I am thinking to disable it on the 9 ~ 16 Rx.Do ...

Perfect! I can work with that setup tonight on the bench. Thank you!!! Next runner up is to program my Compact Wizard Vtail.

Yeah!!! that would be great. I'm sure I can tweak the end point and rates to match this 60 incher.

Seeking assistance for a F3F glider setup for my Taranis Tx: I have a ProdiJ HM Glider. Two Ail, Center Flap section, V-Tail. Looking for: -Normal, Thermal, Reflex on SD switch -Landing on SA switch -Crow -Snap Flap on SC Switch -Diff I am open to experiment with new tips and trick to get the most p...