openrcforums

Hi again.
Problem solved, the LCD was replaced to get another color simultaneous with the board.
Change back to the original and now OK.

Hello. Have purchased 2 of this : https://www.hobbyking.com/hobbyking/store/__78696__Turnigy_9X_Replacement_Mother_Board.html After replacing, the buzzer start to buzz when I connect the battery to the socket, without activating the On/Off switch. It stop buzzing when On/Off swirtch is pushed to On....

Hi. Turnigy 9X standard firmware. Aileron + Flap are used to aileron control. Have maked flaps on an Multiplex Mentor,using both aux channels controled by Hov Pit on channel 7 and 8. Want elevator mix with flaps to control trim. Have put it in Mix 1: STATE = ACT MASTER= AUX SLAVE = ELE DNRATE = 10 S...

Have fixed the problem .
It was one wire from the 3 way switch who ad failed in the 10 pole plug going to main board ( bad work from factory ) .
Now i want to find the mark and discription of the plugs and crimp terminal used on the main board .
Anybody know ?

OK, I will do an better checking of the wiring all the way .
Thanks for your reply .

I have flashed my Turnigy 9xr with open Tx ver: 2.0.7 The three way switch AUX 3 is only showing ID0 in the first pos. ID1 in next pos .but will not show ID2 in last pos., showing ID1 here too. I have change the switch , checked both and they are OK . Also checked the wiring , OK . I also flashed wi...

Hi.
My 9x has the resistor markt 272, but I still has 0.5 volt less on screen .
Measured volt 11.3
Screen 10.8
Any comments ?

Can flashing be done with an PC with Widows Millennium , also called Windows 4.9 ?
Thanks.

Hi. I found this infomation for modification of turnigy 9X with Frsky telemtry. openrcforums.com/wiki/index.php/How_to_modify_your_9x_to_support_telemetry#Overview Question: Can I get telemetry on the screen with this modifications only, or are software download needed ? My TX are 9X V.2 . Regards f...