In my case, the power of the arduino come from the receiver (+ to RAW, - to GND, T to pin4 ant T+1.5 Ko resistor to pin0). This wiring work fine since a year on others home made modules (vario and voltage control).
Best regards
Search found 5 matches
- Sat Mar 25, 2017 6:46 pm
- Forum: OpenXVario - an open source vario supported by the open source firmwares!!
- Topic: OpenXVario HOTT Support
- Replies: 17
- Views: 18927
- Sat Mar 25, 2017 3:08 pm
- Forum: OpenXVario - an open source vario supported by the open source firmwares!!
- Topic: OpenXVario HOTT Support
- Replies: 17
- Views: 18927
Re: OpenXVario HOTT Support
Hello, In fact, it is necessary to put a pull up resistor 1.5 Ko between the Tx (pin 0) and Rx (pin 4) line of the Arduino, the Rx line stay dirctly wire to the T pin of the Data port of the receiver. Now I have the indication on the transmitter that GPS and GAM modules were connected. Thant you for...
- Fri Mar 24, 2017 8:26 pm
- Forum: OpenXVario - an open source vario supported by the open source firmwares!!
- Topic: OpenXVario HOTT Support
- Replies: 17
- Views: 18927
Re: OpenXVario HOTT Support
Thank you for the file but the problem stay the same. In facts, on the Hott system, you have an auto detection of the different modules that you connect to the Hott receiver. This autorise to select then a screen in relation with the module and only tghese screens. For exemple, if you connect only t...
- Fri Mar 24, 2017 6:15 pm
- Forum: OpenXVario - an open source vario supported by the open source firmwares!!
- Topic: OpenXVario HOTT Support
- Replies: 17
- Views: 18927
Re: OpenXVario HOTT Support
Hello,
I'd just send you the file.
Thanks for the help.
I'd just send you the file.
Thanks for the help.
- Thu Mar 23, 2017 8:53 pm
- Forum: OpenXVario - an open source vario supported by the open source firmwares!!
- Topic: OpenXVario HOTT Support
- Replies: 17
- Views: 18927
Re: OpenXSensor V8 HOTT Support
Hello, I'm a Hott telemetry system user and I'm trying to implement the OpenXsensor V8 but I don't have any sensor that appear on the transmitter screen. My setup is Arduino Nano pro mini 5v 16 Mhz with a BMP180 and Neo6 GPS on a GR12 receiver. Is there something more to do than changing the PROTOCO...