openrcforums

I'm awaiting the release if the module as well. Should be almost plug & play other than telemetry. You need to route that to one of the com ports on the sky9x board. There was a thread where the DHT module was modded so there was an extra plug in the back that connected to a com port. Obviously ...

I've committed a new revision today. I've included it in the eepe install file, eepe also updated. If you download and install eepe, you will get eepskye also installed with it. Mike. I need a hint. I started EEPE and it downloaded and installed -- but eepskye is nowhere to be found. Somebody want ...

Flashed r162 and all is working as it should again.

Sounds good. I'll give it a try when you release the update. Thanks Mike!

Hello, I have a V3 Sky9x board with a Frsky DIY module installed. I also have a FBVS-01 voltage sensor hooked up to A2 of a D4R-II receiver. Up until today everything has worked fine. Now however, even though the voltage is displayed (and is correct) my voice alarm that is set to trigger any time vo...

Appreciate the help in figuring it out! I won't be able to test it out till the spare arms for my quad get here. I had some bad luck on my first flight. One of the props broke, just while hovering and the quad flipped over.

Just to clarify, Channels 1-4 should be left alone such as:

0.0 -100% +100%

Channels 5-8 should be as follows:

-20.0 -70% +30%

One thing I just noticed in the original post I linked to above. It appears the CC3D code requires at least a 3.8ms for the sync pulse.

Hello, I am rather new to ER9X. According to this post: http://forums.openpilot.org/topic/16146-cc3d-with-frsky-8-channels-in-cppm-mode/#entry164004 It is possible to limit channels 5-8 to 50% and set all 8 channels SubTrim to minimum so that I can use all 8 channels without losing the sync pulse. T...

My stock order (2) is out of stock for a week or so. I guess I'll have time to read up on how to install them. Any new info about installation tips will be appreciated. SM ShowMaster Sent from my iPod touch using Tapatalk My stick order keeps being pushed back. A guess they say is now Dec24. No rea...