openrcforums

I would like to reverse the direction of my aileron channel with a mix that would be controlled with the 3-way switch. Can this be accomplished? If so how would I go about doing this?

I plugged in a TGY-D1290P servo and then my Edge was not bound to my Tx (Turnigy 9xw/dx4e module running er9x firmware). This is after a crash that took out a servo. When I try to re-bind the LED stops flashing but then goes out instead of going solid and not binding. However, the Edge binds and wor...

Can someone help me out. I need to mix about 7-8% up elevator to the rudder. Seams simple but I am having a hard time. Tried looking for examples and through tutorials, but could not find what I needed to know.

Any body have a template using the Robird G31 FBL/Gryo?

Any body have a Nano QX template?

Anybody have a template for this plane using the stock receiver included with the 9x or the Orange 3axis stabilizer with built in DSM2/X receiver?

Can any body post there eepe file for the Durafly P-51.

Anybody have a template for this plane using the stock receiver included with the 9x or the Orange 3axis stabilizer with built in DSM2/X receiver?

No problem, I didn't figure it out by myself, but was relieved to get rid of the beeping and get out of range check mode. Luckily never had a problem with signal drop out while flying in range check mode.

I got the beeping to go away by deleting all the values for SWC in the switch page. I also edited the mix on channel 1 changing the switch from SWC to THU. BTW beeping means you are in range test mode.

I got the beeping to go away by deleting all the values for SWC in the switch page. I also edited the mix on channel 1 changing the switch from SWC to THU.

Just bought a 130x. Need a template. I currently fly a ncpx & mcpx on my 9x.

I was able to get it by fiddling with the buttons but a write up for noobes would be great. This Tx does a lot but sure is complicated.

I want to set some positive expo. When I try I am only able to put in expo on the top half of the curve resulting in expo in only one direction. I have watched the tutorial vids but there was no mention of programming expo.