Hi, I replaced the micro, and everything was sorted out. Is there any page where pin mapping of the uC is listed for 9x? I tried finding 9x's schematic but with no success, can anyone post a link to the schematic? Thanks
Edit: By pin mapping I mean, which pin is connected to which switch/pot/etc.
Search found 3 matches
- Sun Dec 27, 2015 6:08 pm
- Forum: Electronic Mods
- Topic: Analog input problem after m128 upgrade
- Replies: 8
- Views: 10884
- Wed Dec 23, 2015 11:06 am
- Forum: Electronic Mods
- Topic: Analog input problem after m128 upgrade
- Replies: 8
- Views: 10884
Re: Analog input problem after m128 upgrade
Hi, I did both of them. I did everything I found on this site. I've been debugging this problems since yesterday, but haven't found a reason yet. Do you think that the analog input problem could be due to the fw not being burnt properly? Because I'm pretty confident on my soldering. I'm heading to t...
- Wed Dec 23, 2015 7:50 am
- Forum: Electronic Mods
- Topic: Analog input problem after m128 upgrade
- Replies: 8
- Views: 10884
Analog input problem after m128 upgrade
Hi, I recently upgraded my turnigy 9x with m128 (Atmega128a) and I'm getting this strange problem that both the a1 and a3 values are being controlled by the pitch stick, whereas my yaw stick doesn't have any control. I have checked every point with a continuity tester and there are no solder bridges...