openrcforums

Correct Thanks again

Thanks in advance for any help, getting back into drones after a few years and forgot some things. Using Flysky TH9X flashed with ER9X -r812 v1.142- Mike. Problem is I am only getting the upper half of the throttle range, mid throttle to high, no 0 to mid throttle, with transmitter on display screen...

Replacement stick gimbals ordered, Thanks again

Success Maybe Today I calibrated the sticks 4 more times and now it seems to be working correctly as far as the display graph, have not tried to fly it yet? After the first 3 calibrations there was no change? Only other odd thing I notice is sometimes when I turn the transmitter on I will get a (swi...

yes I have calibrated the sticks a couple of times no change?
Thanks

thanks for help
The ail stick movement works tooooo good, very slightest move to the right or left ail stick and display graph is up to 80 to 100 percent, expo has no effect? There must be something wrong in the ail gimbal pot?
Probably order a new one to see if this is problem?
thanks

Thanks to all for help I have found out there is a problem with the ail movement in the stick control gimbal, only left to right ail movement, elev up and down is OK. The same center stick over sensitivity is present in all the model setup I have stored in this radio? It is like I have expo set to -...

Thanks in advance for any help I am new to ER9X and I have a Flysky TH9X flashed with V1.96 Mike firmware, I am setting up a Trex 450 clone, Emax analog collective servos, Emax digital on tail with a GY401 gyro. I have followed Westy 450 setup guide and everthing seems to be working as it should. Pr...

Thanks in advance for any help Is there anyone that has had success setting up a FBL Trex 450 clone using a APM 2.6 with mission planner helicopter setup and also using a Flysky TH 9X (Turnigy 9X should be the same) (stock firmware)(acro mode) transmitter and a Flysky 8 channel PWM receiver? I am fa...

jhsa Thank you for information. I have USBASP drivers installed ( i believe these are the same used on kkmulticopter flashtool) I have downloaded and installed eepe and eepskye programs. I do not have the board installed in 9x yet, been kind of busy with family stuff. I have watched some of your vid...

Thanks in advance
Can anyone tell me if I can use (without problems) a FS FS-TH9X-B-Module +Antenna for 2.4G 9CH Radio System (Amazon.com) in a Turnigy 9XR transmitter? Wanting to do this because I already have quite a few Flysky receivers
Thanks

Sorry I know this has been explained before but I cannot find a simple guide Thanks in advance for any help Just getting back into RC after many years, am retired now and need some help. Bought from a buddy I have a Flysky FS TH9x stock firmware transmitter, this transmitter came in a package with a...

So I believe someone replied that the Flysky 6 and 8 channel receivers have a sort of a built in failsafe in the fact they will shut off the pulses to the esc and servos? Someone else posted and I believe I have also read where the Flysky receivers do not shut off the pulses to all the channels, som...

Wanting to know if anyone out there thinks this setup is possible? I have a Flysky TH9x stock and am looking for a failsafe product for a 450 helicopter without buying the frysky module and receiver. Could a person use a Flysky 3 channel 2.4gh GR3E with failsafe paired with a Flysky 2.4gh 6 or 8 cha...